Cut String Staircases in Wiltshire
Open-sided stairs with the treads exposed at the string. Manufactured to size and delivered across Wiltshire.
- Made to size from a measured survey, never cut down from stock
- FSC-certified timber with chain-of-custody paperwork
- Fixed written quotation with the lead time stated
- 10-year workmanship guarantee in writing
Free measured survey · No obligation · Reply within one working day
Cut String Staircases in Wiltshire
Free survey and fixed written price.
Cut String Staircases across Wiltshire
Cut String Staircases in Wiltshire is rarely a catalogue job. The building stock is chalk-downland cob and thatch, Bath stone terraces and garrison housing, so we expect variation before we ever pick up a tape. exposed downland wind with driving rain is the local complication, and wind-driven water forced past worn weatherseals is what it eventually causes. The detail we will not compromise on is the cut string profile, where any inaccuracy shows immediately.
We check on site before committing anything to the saw, and we query what does not add up. Tell us the problem rather than the solution and we will advise on both.
A local consideration we always raise: cob and thatch properties need breathable finishes rather than film-forming coatings.
Towns covered
Set out from your rise
Every flight is calculated from the actual floor-to-floor height, measured on site.
Part K compliant
Rise, going, headroom and guarding checked against Building Regulations before manufacture.
Workshop made
Assembled and dry-fitted in the workshop before it ever comes to site.
Installed by our own fitters
The people who fit it work for us, so responsibility does not get passed around.
What clients tell us
Feedback collected directly from completed projects. Full written references are available on request before you commit.
“The headroom was tight and they redesigned the winder rather than telling us it could not be done.”
Verified client, Wiltshire“Dry-assembled in the workshop first, so installation day was genuinely uneventful.”
Verified client, Wiltshire“No squeaks at all a year on, which was the whole reason we replaced the old one.”
Verified client, WiltshireWhat happens next
Four steps from first call to installed joinery. No pressure at any stage.
Site survey
We measure the opening, the floor-to-floor and the headroom ourselves.
Design and setting out
You see the layout and tread arrangement before anything is cut.
Workshop manufacture
Made and dry-assembled in the workshop, then finished.
Installation
Fitted by our own team, with the balustrade set out on site.
Frequently asked questions
Do you cover Wiltshire?
Yes. We cover the whole of Wiltshire including Swindon, Salisbury, Chippenham, Trowbridge and the surrounding villages. Cob and thatch properties need breathable finishes rather than film-forming coatings. Because exposed downland wind with driving rain, we allow for it at survey stage rather than discovering it on the day.
What guarantee do you provide?
Ten years on workmanship, covering manufacture and the factory-applied finish. Where we install, the installation is covered too. It is issued in writing with the handover paperwork.
Do you fit, or supply only?
Both. Supply-only is common for trade and contractor clients. For private clients we usually recommend supply and fit, because responsibility for the fit and the finish then sits in one place.
Is the timber certified?
All our stock is FSC certified and chain-of-custody documentation is supplied with the order, which most main contractors and specifiers now require for their records.
Can you match an existing profile?
Yes. If you can supply a section, a photograph with a rule in shot, or an old unit, we can replicate the profile. For conservation work this is usually the condition the planning officer will apply.
Talk to us about your project
Free, no obligation, and a fixed figure in writing. We will tell you honestly if what you are asking for is not the right answer.
Request a quote Call 0800 088 6248